Piel CP 750 Beryl plans clarification

Répondre
tenns
Formation Théorique
Formation Théorique
Messages : 1
Enregistré le : 05 sept. 2022 20:03

Piel CP 750 Beryl plans clarification

Message par tenns »

Hello all. I'm working on digitizing the CP 750 Beryl using Solid Works with the eventual goal of building an updated version of the design. The plans for the main spar seem unclear regarding the rear shear web. When looking at the dwg it is difficult to decipher if the 3mm plywood is continuous from tip to tip or if it stops at rib station 9 and transitions to 5mm plywood. Based on the hidden line on the "straight" section of the spar I believe there is only 1 layer of plywood on the rear shear web which steps down from 5mm to 3mm but wanted to get others' opinions. I believe the spar design on the Beryl is very similar to the Super Emeraude so perhaps someone with a set of Super Emeraude plans could chime in.

Thanks in advance. Sorry, my French is poor so I had to revert to English.

Tom
Fichiers joints
CP750_low.JPG
CP750_low.JPG (82.93 Kio) Vu 2963 fois
Avatar du membre
AlexZ
Formation Théorique
Formation Théorique
Messages : 21
Enregistré le : 12 oct. 2020 19:15

Re: Piel CP 750 Beryl plans clarification

Message par AlexZ »

Maybe the picture galleries, galerie/thumbnails.php?album=19 give some clarifications.
Alex

Sonex PH-AWX
Vans RV-7A PH-PWP
CP1320 project
miguel ramos
Formation Théorique
Formation Théorique
Messages : 22
Enregistré le : 19 déc. 2005 17:53

Re: Piel CP 750 Beryl plans clarification

Message par miguel ramos »

I was building a Beryl ;stopped but willing to continue migueramos1968@icloud.com
Répondre